Nice Choice Sep 02, 2016

The radiators went together very easily with the connections provided to the heating pex and there were no leaks. very easy to bleed. they provide much more heat than I was getting from my old wall convectors and seem to retain the heat a long time after the boiler is off. Not hard to hang either as long as you separate the hanger prongs in increments of 1/2 inch. Also, my wife was pleasantly surprised by the appearance

Warmwire Heated Floor Jun 03, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more

Reznor Udap-400 Power Vented Gas Fired Unit Heater - Ng - 409 Stainless Steel Heat Exchanger - 400,000 Btu Review Sep 03, 2016

I have owned this same 400k btu unit for 8 years and it is the best purchase that I have ever made. It is used in a commercial setting and has never had a problem or service call. Reznor quality is second to none and definitely worth the extra cost.

Replacement Boiler Apr 15, 2016

I had to buy a boiler to replace one leaking ,putting pilot out..i like the electronic ignition, but seems to be more to go wrong...replace boards $100...standing pilot ,no problems..except leaks in boiler...ill fire warranty claim later...6 year old boiler......i like quality of weil mcclain....we will see about warranty...ps installer now has parkinsons, and will not/can't cooperate......

Energy Efficient, High Quality Product Oct 26, 2016

I installed this unit about a month ago to heat/cool our 3rd floor loft (finished attic) and it has been working flawlessly so far. It is energy efficient and was straightforward to install using the instructions provided and the appropriate tools (torque wrench, vacuum pump in addition to standard tools). I did purchase a genuine Mitsubishi lineset (MLS143812T-15) elsewhere and found that the torque value of 25-30 ft-lb specified for the 3/8" flare connection was too much and it... more